10.6

76Control Surfaces Support Guide
Use the Mix or Output knobset in Logic Pro
The Mix/Output knobset allows you to change the mix or output destination of a channel
strip.
Change the output destination of a channel strip
With your EuCon device connected to Logic Pro:
1. Press the Mix or Output knob top, or key, to display all possible mix or output values for
the currently selected channel strip.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
The value names are displayed on the Soft Keys, the touchscreen, or the display,
depending on the system you are using.
2. To select the output destination, do one of the following:
• Press the knob top that features the name of the mix or output value.
• Press the On key for the relevant mix or output value.
You can use the Page keys to display ensuing outputs.
The currently active output is indicated by a lit On key (on the MC Professional and
MC Mix devices). On the MC Control, it is indicated by a small green LED in the lower
left of the knob image.
3. Press the Back key to return to the top-level knobset.
Euphonix Logic Pro features
This section describes other features specific to Logic Pro.
• Layouts: Tracks assigned to channel strips can be saved as a Layout. This Layout
can then be recalled at a later time. Any Layouts saved on Euphonix devices are
automatically saved with the Logic Pro project.
• Monitors and Control Room: Logic Pro does not support EuCon monitoring control. Use
the Studio Monitor Pro application.
• Control Surface bar: The control surface bar of the Logic Pro Tracks area offers a
special feature on the Euphonix devices: it shows focused tracks in blue.
Note: The color of the control surface bar cannot be changed in the Control Surfaces
Setup inspector.