10.6

74Control Surfaces Support Guide
Change or set a send destination
With your EuCon device connected to Logic Pro:
1. Press the Aux or Sends knob top, or key.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
2. Press both Page keys simultaneously to switch to Send Configuration mode.
The eight Send slots of the currently selected channel strip are displayed.
3. Select the Send slot you want by pressing the respective knob top.
The first eight send destinations are displayed. You can use the Page keys to display
further send destinations (busses).
4. Choose the send destination:
• Pressing the knob top changes, or sets, a selected destination.
• Pressing the Back key navigates up one level in the menu hierarchy.
Use the Euphonix Pan/Surround knobset in Logic Pro
The Pan/Surround knobset allows you to adjust a channel strip’s Pan/Surround control.
If the channel strip’s input format is set to Surround, the knobset displays the following
parameters:
• Surround Angle
• Surround Diversity
• LFE Level
• Surround X (left/right)
• Surround Y (front/back)
• Spread
• Center Level
Adjust the pan/surround control
With your EuCon device connected to Logic Pro:
1. Press the Pan/Surround knob top, or key, to display the Pan/Surround parameters for
the currently selected channel strip.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
The parameter names are displayed on the Soft Keys, the touchscreen, or the display,
depending on the system you are using.
2. Rotate the respective knob to change the parameter value.
Pressing a knob top sets the controlled parameter to its default value.
3. Press the Back key to return to the top-level knobset.