10.6

73Control Surfaces Support Guide
When no Channel or Linear Phase EQ is present on the selected channel strip, pressing the
knob top labeled AddChEQ inserts a Channel EQ.
• The first knob of an EQ band (the upper or left knob of the pair) controls either
Frequency or Q. To switch between Frequency and Q, use the Select/SEL key if working
with the MC Professional devices or the MC Mix. If using the MC Control, press the Shift
key while touching the knob’s image on the touchscreen. (When active, a small yellow
LED lights on the upper left of the image.) Pressing the knob top sets the controlled
parameter to its default value.
• The second knob of an EQ band (the lower or right knob of the pair) controls Gain (or
Slope). Pressing the knob top sets the controlled parameter to its default value.
• If working with the MC Professional devices or the MC Mix, the On key switches the
bypass state of the band. On the MC Control, press the knob’s touchscreen image.
Edit an EQ plug-in
With your EuCon device connected to Logic Pro:
1. Press the EQ knob top, or key, to display the EQ bands of the EQ plug-in inserted in the
currently selected channel strip.
Note: The MC Mix automatically switches to Channel mode.
The EQ band parameters are displayed on the Soft Keys, the touchscreen, or the display,
depending on the system you are using.
You can use the Page keys to display ensuing parameters.
2. Rotate the respective knob to change the parameter value.
Pressing a knob top sets the controlled parameter to its default value.
3. Press the Back key to return to the top-level knobset.
Use the Euphonix Aux or Sends knobset in Logic Pro
The Aux or Sends (Configuration) knobset allows you to:
• Edit a send destination (Aux or Sends mode)
• Change or set a send destination (Aux or Sends Configuration mode)
The Select key (labeled SEL on the MC Mix) switches between Pre Fader (off—unlit) and
Post Fader (on—lit) modes.
Edit a send destination
With your EuCon device connected to Logic Pro:
1. Press the Aux or Sends knob top, or key, to display all send options for the currently
selected channel strip.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
The send options are displayed on the Soft Keys, the touchscreen, or the display,
depending on the system you are using.
2. Rotate the respective knob to change the send level.
Pressing a knob top sets the controlled parameter to its default level.
3. Press the Back key to return to the top-level knobset.