10.6

68Control Surfaces Support Guide
Choose an automation mode on a CM408T channel strip
With your CM408T connected to Logic Pro:
1. Press the Wave and Y keys simultaneously.
The available automation modes are displayed in a pop-up menu on the CM408T display.
2. Use the fader of the channel strip to scroll through the following options:
• Isolate: Automation mode is Off.
• Read: Activates Read mode in Logic Pro.
• Write: Activates Write mode in Logic Pro.
• Read/Write: Activates Touch mode in Logic Pro.
3. Use the Y key to confirm your selection, or the N key to cancel the operation.
Note: If a write automation mode (Touch, Latch, Write) is active (and an automation
parameter is enabled in the Logic Pro > Preferences > Automation > Touch/Latch/Write
Erase settings), the red “W” LED is lit. The green LED is lit when a read automation mode is
active. Both LEDs are lit when Touch or Latch mode is active.
Choose an automation mode on MC Artist devices
With your MC Artist device connected to Logic Pro:
1. Hold down the Shift key.
2. Press the AUTO key repeatedly until your chosen automation mode appears on the
display screen. You can choose between:
• Blank: Automation mode is Off.
• Read (r): Activates Read mode in Logic Pro.
• Write (w): Activates Write mode in Logic Pro.
• Read/Write (rw): Activates Touch mode in Logic Pro.
Euphonix fader strips in Logic Pro
The number of fader strips differs across each of the Euphonix devices. This section
outlines the behavior of some fader strip elements in Logic Pro.
Note: This section is limited to descriptions of features specific to Logic Pro. Refer to the
Euphonix user documentation for information about basic fader behavior.
• On key: The On key provides the same function as the Mute button in Logic Pro but
behaves in a way that may not be expected.
• The track is unmuted when the On key is lit (the Logic Pro Mute button is unlit).
• The track is muted when the On key is unlit (the Logic Pro Mute button is lit).
• L LED: On MC Professional devices, when the Logic Pro channel strip being controlled
by the fader belongs to an automation group, the L LED of the channel strip is lit.
• Touching fader selects track: The “Touching fader selects track” preference of
Logic Pro does not apply to the Euphonix devices when they are used with the EuCon
protocol. This function is offered by the individual devices, using the device’s “Select
channel by touching fader/joystick” or “Select by Touch” General preference. This is the
same as pressing the Select/Sel key.