10.6

36Control Surfaces Support Guide
Mackie Control Large Marker mode in Logic Pro
Hold the SHIFT button, then press the MARKER button to show three create options on the
LCD, assigned to the three rightmost V-Pot buttons.
Once markers have been created, press the V-Pot button listed below to create or delete a
marker at the current playhead position.
Control Action
V-Pot 1 to 5 Displays the first five markers by name. Pressing a V-Pot button moves
the playhead to the corresponding marker. When the playhead position is
inside a marker, the lower line displays INSIDE, and the V-Pot LED ring is
lit.
V-Pot 6 Cr w/o—Creates a marker, without rounding to the nearest bar.
V-Pot 7 Create—Creates a marker, rounded to the nearest bar.
V-Pot 8 Delete—Deletes the marker above the current playhead position.
A recommended workflow for creating or deleting markers is to use the Jog/Scrub Wheel.
Turn the wheel to move the playhead to the required project position, and then press the
appropriate V-Pot to create or delete a marker.
• For coarse placement, use the wheel to move the playhead.
• For fine placement, press the SCRUB button, then use the wheel to precisely position
the playhead. (This technique is only appropriate if creating or deleting an unrounded
marker.)
For more information about using the Jog/Scrub Wheel, see Mackie Control Jog/Scrub
wheel in Logic Pro.
Large Marker mode is ended by pressing the MARKER button again.
Mackie Control Nudge button
Mackie Control Nudge button in Logic Pro
The NUDGE button allows you to move (nudge) selected audio or MIDI regions (or events)
in Small, Large, or Temporary Nudge mode.
Note: The Marker and Nudge modes are mutually exclusive; activating one deactivates the
other.
• Small Nudge mode: Press the NUDGE button to reassign the behavior of the FAST
FWD and REWIND buttons; pressing either FAST FWD or REWIND nudges the selected
regions or events by the value defined in Large Nudge mode. Pressing the NUDGE
button a second time reverts to the default behavior of the FAST FWD and REWIND
buttons. (See Mackie Control transport buttons in Logic Pro.) Small Nudge mode is
useful if you want to nudge regions or events but still use the V-Pots for other purposes.
• Large Nudge mode: Hold down the SHIFT button, then press the NUDGE button to show
eight functions on the LCD that are mapped to the corresponding V-Pot buttons. These
functions allow you to move the selected region or events by various amounts or to a
specific position. See Mackie Control Large Nudge mode in Logic Pro.