10.6

23Control Surfaces Support Guide
Control Action
V-Pot 8 or F8 Switches to Destination/Level Channel view. You can control all Send
slots for the selected channel strip in this mode. Each channel strip
corresponds to the (embossed) send number shown below the LCD.
• The mode display shows “dL.”
• Rotating a V-Pot preselects the corresponding send destination.
• Pressing a V-Pot confirms a preselected send destination.
• The Solo buttons edit send position—a lit Solo LED indicates Pre Fader
mode.
• The MUTE buttons set the send mute state.
• The faders edit the send gain.
If one or more sends are activated on multiple channels, you can switch between them
while in the Channel views by pressing the SELECT button of the channel.
Mackie Control Plug-in button
Mackie Control Plug-in button in Logic Pro
Press the PLUG-IN button to activate Mackie Control Plug-in Mixer view in Logic Pro.
Press the PLUG-IN button repeatedly to switch between Plug-in Mixer view and Mackie
Control Plug-in Channel view in Logic Pro.
Note: There is one exception to this behavior. If you are in Instrument Edit view, pressing
the PLUG-IN button switches to Mackie Plug-in edit view in Logic Pro. For more
information, see Mackie Control Instrument edit view in Logic Pro.
Mackie Control Plug-in Mixer view in Logic Pro
In this view, you can edit the plug-ins associated with a particular Insert slot for all
channels. The mode display shows P1 to P9, or 10 to 16, indicating the selected Insert slot
number.
Note: If a software instrument channel is selected, the display shows P1 to P9 and 10 to 15.
In Plug-in Mixer view:
• The upper row of the LCD shows channel strip names.
• The lower row of the LCD shows the currently selected plug-in for the active Insert slot.
Muted plug-ins are shown with an asterisk (*) that precedes the plug-in name.
• Rotating the V-Pots preselects a new plug-in. The plug-in name flashes until confirmed
by pressing the V-Pot button.
• Rotating another channel’s V-Pot cancels any earlier preselection, and starts
preselection on the newly selected channel strip.
• Pressing a V-Pot button:
• Confirms or activates the preselected plug-in (assuming that you’ve made your
preselection by rotating the V-Pot).
• Opens a plug-in window, if none is open. If a plug-in window is open and Link mode
is turned on, the selection of another plug-in replaces the existing plug-in window.
• Switches to Plug-in Edit view.