10.6

191Control Surfaces Support Guide
Yamaha DM1000
Set up your Yamaha DM1000 in Logic Pro
Follow these steps to use your DM1000 with Logic Pro.
• Make sure that your DM1000 device is connected to the computer via USB.
• Make sure that the latest USB MIDI driver for the device is installed. Visit the
manufacturer’s website to download the most recent driver version, if necessary.
Set up your DM1000 with Logic Pro
1. On the DM1000 device, do the following:
• Press the DISPLAY ACCESS [SETUP] button repeatedly, until the Setup > MIDI/Host
page is visible.
• Use the cursor buttons to move to the DAW parameter box in the SPECIAL
FUNCTIONS section, and rotate the parameter wheel to select USB and 1–3.
• Press the DISPLAY ACCESS [REMOTE] button, and then press the [F1] button. The
Remote 1 page is displayed.
• Rotate the parameter wheel to choose General DAW as the TARGET parameter.
• Press the LAYER [REMOTE 1] button.
2. In Logic Pro:
When you open Logic Pro, the DM1000 device is installed automatically. You should see
two DM1000 icons in the Setup window, aligned horizontally.
DM1000 assignments
Yamaha DM1000 assignments overview in Logic Pro
These sections outline the assignment of Yamaha DM1000 interface elements to Logic Pro
functions.
• Yamaha DM1000 Display Access controls in Logic Pro
• Yamaha DM1000 Aux Select controls in Logic Pro
• Yamaha DM1000 Encoder and Fader Mode controls in Logic Pro
• Yamaha DM1000 LCD controls in Logic Pro
• Overview of DM1000 LCD display modes in Logic Pro