10.6

187Control Surfaces Support Guide
Yamaha 02R96 Effect/Plug-in controls in Logic Pro
The table outlines the EFFECT/PLUG-IN controls and their assignments.
Control Assignment
Display Opens or closes the Sample Editor.
PLUG-INS Switches SEL buttons and encoder buttons between normal behavior and
setting a parameter’s default value.
CHANNEL INSERTS Determines mode of channel strip SEL buttons:
• Indicator off: SEL button used for channel strip selection
• Indicator on: SEL button used for Insert selection
2 Switches the display between “track name/parameter name” and
“parameter name/parameter value” modes.
3 Switches the bypass state of plug-in currently being edited.
4 Switches between Plug-in Assign and Plug-in Edit modes.
Parameter Up & Parameter Down Plug-in Edit mode: shifts the parameter display to show the next/previous
page of parameter controls (usually four) for the selected plug-in.
Selecting virtual encoders 1 to 4
(Use cursor keys, and then press
ENTER button.)
Pan Assignment mode:
• Parameter control 1 button centers pan or surround angle.
• Parameter control 2 button centers surround diversity.
• Parameter control 3 button resets surround LFE level.
• Parameter control 4 button resets spread.
Send Assignment mode:
• Enables or disables Sends 1 to 4 or 5 to 8.
Plug-in Assignment mode:
• Confirms the plug-in selection for Insert slots 1 to 4 or 5 to 8, and
enters Plug-in Edit mode for the selected Insert slot.
Plug-in Edit mode:
• Sets value to default, or switches buttons with two states.
Moving virtual encoders 1 to 4
(Use cursor keys, and then rotate
parameter wheel.)
Pan Assignment mode:
• Parameter control 1 edits pan or surround angle.
• Parameter control 2 edits surround diversity.
• Parameter control 3 edits surround LFE.
• Parameter control 4 edits spread.
Send Assignment mode:
• Controls the Send level of Sends 1 to 4 or 5 to 8.
Plug-in Assignment mode:
• Chooses Insert slot 1 to 4 or 5 to 8.
Plug-in Edit mode:
• Sets value.