10.6

172Control Surfaces Support Guide
Tascam US-2400 Plug-in Edit view in Logic Pro
In Plug-in Edit view, some AUX buttons have special assignments.
Control Assignment
AUX 1 Scrolls parameter fader bank left by 24 parameters.
AUX 2 Scrolls parameter fader bank right by 24 parameters.
AUX 3 Increments Insert slot (chooses higher-numbered slot).
AUX 4 Enables or disables Bypass button of the plug-in being edited.
AUX 6 Decrements Insert slot (chooses lower-numbered slot).
The AUX button LEDs show the currently selected Insert slot. For example, AUX 2 LED is
on if Insert slot 2 is being edited.
Tascam US-2400 master section controls in Logic Pro
The table outlines the master section controls and their assignments.
Note: A modifier button, such as SHIFT, below a control description indicates that the
control has an alternate use while the modifier is held down.
Control Modifier Assignment
MTR Switches encoder LED ring display
between two modes:
• The value of the parameter (LED
off)
• Level/peak hold meters (LED on)
In Level Meter mode, the LED
below the encoder displays signal
overloads (clipping).
F-KEY Modifier key, used to switch the
function of other controls (see
“F-KEY” entries in center column).
NULL Sets Surround x/y or Panning of
selected channel to center position;
LED is on if Surround X (or Panning)
is centered.
F-KEY Resets overload display for level
meters.
Jog Wheel SCRUB off: moves playhead by bars.
SCRUB on: scrubbing (of audio and
MIDI).
SCRUB flashing: Shuttle mode.
Joystick Edits Surround x/y or Panning of
selected channel.
SCRUB Switches Jog Wheel between Move
Playhead by Bars (LED off) and
Scrubbing (LED on) modes.