10.6

170Control Surfaces Support Guide
Tascam US-2400 master channel in Logic Pro
The table outlines the master channel strip controls and their assignments.
Control Assignment
SEL Selects Master Output channel strip
if it exists; if not, Output channel
1–2 is selected.
CLR SOLO Disables Solo for all tracks/
channels.
SHIFT Disables Mute for all tracks/
channels.
F-KEY Disables the Record Enable buttons
of all tracks/channels.
FLIP Switches Flip mode between Off
(LED off) and Duplicate (LED on).
In this mode, the fader of each
channel strip mirrors the encoder
function.
SHIFT Sets Flip mode to Swap (LED
flashing). In this mode, the
parameters controlled by the fader
and encoder are swapped.
F-KEY Sets Flip mode to Zero—fader
motors are disabled (LED flashing).
US-2400 encoder assignments
Overview of Tascam US-2400 encoder assignments in Logic Pro
The table outlines the standard assignment of the encoders. Also see Tascam US-2400
Instrument Edit view in Logic Pro and Tascam US-2400 Plug-in Edit view in Logic Pro for
information on alternate use of the encoders.
Note: A modifier button, such as SHIFT, below a control description indicates that the
control has an alternate use while the modifier is held down.
Control Modifier Assignment
CHAN Switches encoders to Channel view
(see encoders’ legend); CHAN
button LED is lit.
F-KEY Switches encoders to Instrument
Edit view; CHAN button LED flashes.
See Tascam US-2400 Instrument
Edit view in Logic Pro for details.
PAN Switches encoders to Mixer
(multichannel) view of pan controls;
PAN button LED is lit.