10.6

166Control Surfaces Support Guide
Tascam US-2400
Set up your Tascam US-2400 in Logic Pro
The US-2400 is capable of running in both native and Mackie Control emulation modes.
If the unit is set up in Mackie Control emulation mode, and the native support plug-in is
installed in the Logic Pro program bundle, Logic Pro detects a US-2400 native control
surface and a Mackie Control, plus two Extender (XT) units.
To run the US-2400 in Mackie Control mode, remove the US-2400 plug-in from the
Logic Pro application bundle. Logic Pro will then detect a Mackie Control plus two Extender
(XT) units (the appropriate setup for the US-2400 in Mackie Control emulation mode) when
you scan for control surfaces.
The button layout of the Mackie Control differs from that of the Tascam US-2400. When
running the Tascam US-2400 in Mackie Control mode, certain controllers are not
accessible (the Joystick, for example). Given these restrictions, use of the Tascam US-
2400 in Mackie Control mode is not recommended. If you choose to do so, refer to the
documentation supplied with the Tascam US-2400 for details.
Follow the steps below to use your Tascam US-2400 with Logic Pro.
Set up the Tascam US-2400 for use with Logic Pro
1. Make sure that your US-2400 control surfaces are connected to the computer via USB.
2. Ensure that the US-2400 is in native mode. Consult your US-2400 manual for more
information on this setting.
3. Open Logic Pro.
Your control surfaces are scanned for, and installed, automatically.
US-2400 assignments
Overview of Tascam US-2400 assignments in Logic Pro
These sections outline the assignment of Tascam US-2400 interface elements to Logic Pro
functions.
• Tascam US-2400 channel strips in Logic Pro
• Tascam US-2400 encoders in Logic Pro
• Tascam US-2400 master channel in Logic Pro
• Overview of Tascam US-2400 encoder assignments in Logic Pro
• Tascam US-2400 master section controls in Logic Pro