10.6

162Control Surfaces Support Guide
Roland SI-24 status mode controls in Logic Pro
The table outlines the status mode controls and their assignments.
Note: A modifier button (such as SHIFT) shown below a button description indicates that
the button has an alternate use while the modifier is held down.
Control Modifier Assignment
AUTOMIX Sets STATUS 1 to 12 buttons to
Automation mode.
SHIFT Sets all tracks to Off, Read,
Latch, or Write automation mode.
Repeatedly press this button
combination to cycle through
automation modes.
REC/PLAY Sets STATUS 1 to 12 buttons to
Record Enable mode.
SOLO Sets STATUS 1 to 12 buttons to Solo
mode.
MUTE Sets STATUS 1 to 12 buttons to
Mute mode.
Roland SI-24 channel assign controls in Logic Pro
The table outlines the channel assign controls and their assignments.
Note: A modifier button (such as SHIFT) shown below a button description indicates that
the button has an alternate use while the modifier is held down.
Control Modifier Assignment
INPUT Shows the first 12 audio input
channel strips.
SHIFT Shows the first 12 MIDI channel
strips.
OUTPUT Shows the first 12 output channel
strips:
• 1: Output 1–2 (default surround
assignment: front)
• 2: Output 3–4 (default surround
assignment: rear)
• 3: Output 5 (default surround
assignment: center)
• 4: Output 6 (default surround
assignment: LFE)
• 5: Output 7–8 (digital out)
SHIFT Shows the first 12 audio channels.
BUS Shows the first 12 aux channels.
SHIFT Shows the first 12 instrument
channels.