10.6

148Control Surfaces Support Guide
Change mix parameters on the Launchpad
Pro, Launchpad X, and Launchpad Mini MK3 in
Logic Pro
When you access the mixing parameters described below on the Launchpad Pro,
Launchpad X, or Launchpad Mini MK3 models, the first column of pads switches to a
temporary mode that you can use to change the parameters for each track. Use the Up and
Down arrows on the Launchpad to scroll through the tracks. While this temporary mode is
active, the rest of the pads continue to function as they do in Session mode.
The following mixing parameters use this function:
• Record Arm mode: The first pad column turns the Record Ready state of the track on
and off.
• Track Select mode: The first pad column selects the track (Launchpad Pro only).
• Mute mode: The first pad column mutes and unmutes the track.
• Solo mode: The first pad solos and unsolos the track.
• Stop Clip mode: The first pad column stops the cell playing on the track.
The Launchpad Pro has individual buttons you can use to access each mix parameter. On
the Launchpad X and Launchpad Mini MK3 models, press the Session button to switch
between Session and Mixer modes, then use the Scene buttons to access each individual
mix parameter. On the Launchpad Pro, the buttons used to access the mix parameters have
two modes: Latch and Momentary.
• Latch: Press and release the button. Latch mode stays enabled until you press the
button again, or you press another button to access another mix parameter.
• Momentary: Press and hold the button, then press one or more of the pads to change
parameters, Release the Scene or Mixer button to exit Momentary mode.