10.6

114Control Surfaces Support Guide
Control Modifier Assignment
SEND D As above, for Send 4
SEND E As above, for Send 5
PAN Assigns Pan to V-Pots, and the
selected (surround) channel
strip’s pan/surround parameters to
DSP V-Pots. You must confirm any
changes made with the DSP V-Pots
by pressing the corresponding
V-Select button.
INPUT Assigns channel strip input to
V-Pots. While held down, the
scribble strips show the current
channel strip input assignment.
The four DSP V-Pots control the
following parameters of the selected
channel strip: format, input, output,
and automation mode. You must
confirm any changes made with the
V-Pots or DSP V-Pots by pressing
the corresponding V-Select button.
OUTPUT Assigns channel strip output to
V-Pots. While held down, the
scribble strips show the current
channel strip output assignment.
The four DSP V-Pots control the
following parameters of the selected
channel strip: format, input, output,
and automation mode. You must
confirm any changes made with the
V-Pots or DSP V-Pots by pressing
the corresponding V-Select button.
REC/RDY ALL Disables Record Enable button of all
channel strips.
BYPASS Switches the INSERT buttons
between Insert Select and Insert
Bypass modes. See the Insert entry
in the table on Mackie HUI channel
strips in Logic Pro.
MUTE Switches the V-Select buttons
between Send Position and Send
Mute modes.
SHIFT Enables or disables Flip mode.
SELECT-ASSIGN Displays the V-Pot assignment as
follows: Pan, Snd1 to Snd8, S1As to
S8As, In, Out.
SUSPEND —
DEFAULT Hold down this button to switch the
V-Select buttons between standard
operation and setting default
values.