10.6

112Control Surfaces Support Guide
Mackie HUI
Set up your Mackie HUI with Logic Pro
HUI control surface devices don’t support automatic scanning. You need to manually add
these devices to your setup. When you add a device in this way, you need to assign the
MIDI In and Out port parameters.
Important: There are a number of control surfaces—not mentioned in this guide—that can
emulate the HUI. Such devices are not supported by Apple, nor are they guaranteed to
work with Logic Pro in HUI emulation mode.
If the unit emulates a single HUI device, proceed as if using a HUI.
If you experience problems in the DSP Edit display, install the unit as a DM2000. See Set
up your Yamaha DM2000 in Logic Pro.
If the unit emulates more than one HUI, add the required number of additional devices in
the Setup window. If the unit is limited to support of only one HUI DSP Edit section, choose
“HUI Channel Strips only” as the model name for these additional units. This ensures that
scrolling in the DSP Edit section is limited to four parameters.
If you want to know more about button assignments, refer to Overview of Mackie HUI
assignments in Logic Pro and the user manual for the device.
Set up Mackie HUI devices
To use Mackie HUI devices with Logic Pro:
1. Make sure that your HUI devices are connected bidirectionally with the computer, using
a MIDI interface.
2. Choose Logic Pro > Control Surfaces > Setup.
3. Choose New > Install in the Setup window.
4. Select HUI in the Install window.
5. Click the Add button.
6. Select the added device in the Setup window, then set the MIDI In and MIDI Out
parameters as appropriate.