10.6

107Control Surfaces Support Guide
Korg microKONTROL and KONTROL49 channel strips in
Logic Pro
There are several modes for the encoders, enabled with SCENE and Pad 9–16.
Control Assignment
LCD Shows the parameter controlled by the encoder. The current name/value is
displayed for a few seconds when you move an encoder or a fader.
When the encoders are in a Mixer view (Pan, Send, Send Setup), the
background color indicates the channel automation mode:
• Green: Off or Read
• Yellow: Touch or Latch
• Red: Write
Encoder Controls the parameter shown directly above the encoder in the LCD.
Fader Controls volume. Because the faders don’t offer feedback, Pickup mode is
used (if enabled in the Control Surfaces preferences). This means that the
fader must reach (“pick up”) the current parameter value before the value
starts to change.
microKONTROL and KONTROL49 external input in Logic Pro
The table outlines the external input controls and their assignments.
Control Assignment
Foot Switch Starts and stops playback.
Pedal Controls the master fader.