10.6

102Control Surfaces Support Guide
Korg microKONTROL and KONTROL49
Set up Korg microKONTROL and KONTROL49 in
Logic Pro
Follow the steps below to use your control surface with Logic Pro.
Set up your Korg control surface with Logic Pro
1. Ensure that your control surfaces are connected to the computer via USB.
2. Open Logic Pro.
The devices are scanned for and installed automatically. The microKONTROL/
KONTROL49 is automatically set to native mode; internal Scene settings are ignored.
Note: If installation and identification fails, it may be possible that the microKONTROL/
KONTROL49 reaction time is too slow due to USB bus-power issues. In this situation,
connect the supplied power adapter, and set the power switch to the DC position.
When you quit Logic Pro (or delete the control surface icon in the Control Surfaces Setup
window), the microKONTROL/KONTROL49 is reset to normal (non-native) operation.
microKONTROL and KONTROL49 assignments
microKONTROL and KONTROL49 Pads
Overview of Korg microKONTROL and KONTROL49 Pads in Logic Pro
The Pads can operate in one of eight modes, and three overlays. While pressing SCENE,
you can select modes for the Pads and channel strips. Releasing SCENE without pressing a
Pad does not affect the currently selected Pad or channel views.
Pad Assignment
1 Switches Pads to Korg microKONTROL and KONTROL49 Transport mode
in Logic Pro.
2 Switches Pads to Korg microKONTROL and KONTROL49 Solo/Mute mode
in Logic Pro.
3 Switches Pads to Korg microKONTROL and KONTROL49 Rec/Select mode
in Logic Pro mode.