9

If you want your key command assignment to be executed repeatedly, select the Key
Repeat checkbox at the bottom of the Controller Assignments window. For further
information, see “Key Repeat Checkbox” in Editing Value Parameters in Expert View.
Click the Show button to open the Key Commands window. The key command shown
in the Command field is automatically selected and shown in the Key Commands window.
Control Surface Group
Choosing the Control Surface Group class allows you to set a property for the control
surface group (that the assignment belongs to). When you choose this class, a Parameter
pop-up menu appears below the Class pop-up menu. This pop-up menu allows you to
choose one of the options described in Control Surface Group Parameters, or one from
those listed in the following table.
Note that assignments for unsupported control surfaces always belong to the first control
surface group.
Additional infoParameter option
Maps to the fader bank for the currently used View mode. This way,
you need only one assignment per left/right button for all View
modes.
Fader Bank for Current View
When this parameter is selected, eight additional checkboxes (for
the eight channel strip types) are displayed, when the View mode
is All. Depending on the Value mode, these switches define which
channel strips are displayed (by using Direct mode) or which are
toggled (by using X-OR mode).
Filter for All View
These fader bank parameters are used in All View when only one
channel strip type is displayed. This allows you to switch between
several channel strip types, while retaining the current fader bank
for each type.
Fader Bank for: MIDI Channel
Strips, Input Channel Strips,
Audio Channel Strips, Instrument
Channel Strips, Aux Channel
Strips, Bus Channel Strips,
Output Channel Strips
If you choose one of the fader bank or parameter page settings in the Parameter pop-up
menu, the following Bank Type options appear below the pop-up menu.
• By One: The fader bank or parameter page is shifted by one channel strip or parameter.
• By Bank: The fader bank or parameter page is shifted by the number of displayed
channel strips or parameters.
• CS Group Setting: The fader bank or parameter page is shifted by the value defined for
the Parameter Page Shift Mode control surface group parameter.
Automation Group
Choosing the Automation Group class allows you to use the assignment to set an
automation group parameter.
54 Chapter 2 Customizing Controller Assignments