9

AssignmentDisplay
Displays the encoder assignment as follows: Pan, Snd1 to Snd8,
S1As to S8As, In, Out.
SELECT ASSIGN
Insert Display Mode
Press the F2 button to select Insert Display mode. In this mode, the LCD displays
parameters, allowing you to edit effects. This mode also allows you to switch between
different Insert slots, enabling each effect to be edited.
AssignmentControl
Switches the display between “track name/parameter name” and
“parameter name/parameter value” modes.
COMPARE
Switches the bypass state of plug-in currently being edited.BYPASS
Switches between Plug-in Assign and Plug-in Edit modes.INSERT/PARAM
Pan Assignment mode:
• Parameter control 1 button centers pan angle.
Send Assignment mode:
• Enables/disables Sends 1 to 4 or 5 to 8.
Plug-in Assignment mode:
• Confirms the plug-in selection for Insert slots 1 to 4 or 5 to 8, and
enters Plug-in Edit mode for the selected Insert slot.
Plug-In Edit mode:
• Sets value to default, or switches buttons with two states.
Selecting virtual encoders 1 to 4
(Use cursor keys, and then press
ENTER button.)
Pan Assignment mode:
• Parameter control 1 edits pan angle.
Send Assignment mode:
• Controls the Send level of Sends 1 to 4 or 5 to 8.
Plug-in Assignment mode:
• Chooses Insert slot 1 to 4 or 5 to 8.
Plug-in Edit mode:
• Sets value.
Moving virtual encoders 1 to 4
(Use cursor keys, and then rotate
parameter wheel.)
Channel Display Mode
Press the F3 button to select Channel Display mode. In this mode, the parameter controls,
such as pan and send level, for channel strips 1 to 16 are displayed.
AssignmentControl
When Send 1 to 8 is selected: edits Send pre/post fader position,
enables or disables Send mute, or sets Send level to default value.
Send, Input, or Output Assignment mode: confirms selection.
Selecting virtual encoders 1 to 4
(Use cursor keys, and then press
ENTER button.)
264 Chapter 23 Yamaha DM1000