9

Control Surface Group Other Parameters
The parameters at the bottom of the Control Surface Group Parameters area let you set
the Track Name Format, Parameter Page Shift Mode, Relative Change Mode, Mix Group,
and Group Parameter Page parameters.
• Track Name Format: Determines whether the track name display shows only the track
name, or the track name and number.
• Parameter Page Shift Mode: Determines whether the parameter is shifted by one page
or by one parameter.
• Relative Change Mode: Choose the mode for controller assignments that support a
Relative Value Change mode (rotary encoders, for example). The choices are:
• Coarse: The parameter is adjusted in coarse steps.
• Full: Turning the encoder to the right sets the maximum value. Turning it to the left
sets the minimum value. The encoder also stops at its default value. For example,
when the Pan knob is left of center, turning the encoder to the right initially sets the
Pan parameter to center (its default value). A further turn to the right sets the Pan
to full right (its maximum value).
• Fine: The parameter is incremented or decremented in fine steps—by one tick or
other unit. In this mode, the highest possible resolution is used. For example, when
editing the Sample Delay plug-in’s Delay parameter, every encoder tick increases or
decreases the value by 1 sample, regardless of the resolution value.
• Mix Group: Determines which group is edited when in Group Edit mode.
• Group Parameter Page: Defines which parameter of the edited group is assigned to the
leftmost encoder.
Setting Control Surfaces Preferences
Various settings that affect the onscreen appearance and performance of control surfaces
can be made in the Logic Express Control Surfaces preferences.
To open the Control Surfaces preferences
µ
Choose Logic Express > Preferences > Control Surfaces > Preferences (or use the Open
Control Surfaces Preferences key command).
26 Chapter 1 Basic Control Surface Setup