9

Plug-in Edit View
In Plug-in Edit view, the following AUX buttons have special assignments:
AssignmentControl
Scrolls parameter fader bank left by 24 parameters.AUX 1
Scrolls parameter fader bank right by 24 parameters.AUX 2
Increments Insert slot (chooses higher-numbered slot).AUX 3
Enables/disables Bypass button of the plug-in being edited.AUX 4
Decrements Insert slot (chooses lower-numbered slot).AUX 6
The AUX button LEDs show the currently selected Insert slot. For example, AUX 2 LED is
on if Insert slot 2 is being edited.
Tascam US-2400: Master Section
The following table outlines the master section controls and their assignments:
Note: A modifier button, such as SHIFT, below a control description indicates that the
control has an alternate function or use while the modifier is held down.
AssignmentModifierControl
Switches encoder LED ring display between two
modes:
• The value of the parameter (LED off)
• Level/peak hold meters (LED on)
In Level Meter mode, the LED below the encoder
displays signal overloads (clipping).
MTR
Modifier key, used to switch the function of other
controls (see “F-KEY” entries in left column).
F-KEY
Sets Panning of selected channel to center
position; LED is on if Panning is centered.
NULL
Resets overload display for level meters.F-KEY
SCRUB off: moves playhead by bars.
SCRUB on: scrubbing (of audio and MIDI).
SCRUB flashing: Shuttle mode.
Jog Wheel
Edits Panning of selected channel.Joystick
Switches Jog Wheel between “Move Playhead by
Bars” (LED off) and Scrubbing (LED on) modes.
SCRUB
Sets Jog Wheel to Shuttle mode (LED flashes).SHIFT
Shifts fader bank to the left by one bank; LED is lit
if the leftmost fader bank has not been reached.
BANK –
Shifts fader bank to the left by one channel.F-KEY
235Chapter 19 Tascam US-2400