9

AssignmentControl
Controls the Q factor of band 7, if a Channel EQ is inserted.Encoder 19 (Q 3)
Controls the Slope parameter of band 8, if a Channel EQ is inserted.Encoder 20 (GAIN 4)
Controls the Frequency parameter of band 8, if a Channel EQ is
inserted.
Encoder 21 (FREQ 4)
Controls the Q factor of band 8, if a Channel EQ is inserted.Encoder 22 (Q 4)
Controls Pan/Balance (of mono or stereo channels).Encoder 24 (PAN)
Tascam US-2400: Master Channel
The following table outlines the master channel strip controls and their assignments:
AssignmentControl
Selects Master Output channel strip if it exists; if
not, Output channel 1–2 is selected.
SEL
Disables Solo for all tracks/channels.CLR SOLO
Disables Mute for all tracks/channels.SHIFT
Disables the Record Enable buttons of all
tracks/channels.
F-KEY
Switches Flip mode between Off (LED off) and
Duplicate (LED on). In this mode, the fader of each
channel strip mirrors the encoder function.
FLIP
Sets Flip mode to Swap (LED flashing). In this
mode, the parameters controlled by the fader and
encoder are swapped.
SHIFT
Sets Flip mode to Zero—fader motors are disabled
(LED flashing).
F-KEY
Tascam US-2400: Encoder Assignment Section
The table below outlines the standard assignment of these controls:
Note: A modifier button, such as SHIFT, below a control description indicates that the
control has an alternate function or use while the modifier is held down.
AssignmentModifierControl
Switches encoders to Channel view (see encoders’
legend); CHAN button LED is lit.
CHAN
Switches encoders to Instrument Edit view; CHAN
button LED flashes. See Instrument Edit View for
details.
F-KEY
Switches encoders to Mixer (multichannel) view
of pan controls; PAN button LED is lit.
PAN
233Chapter 19 Tascam US-2400