9

Using the US-2400 in Native or Mackie Control Emulation Mode
The US-2400 is capable of running in both Native and Mackie Control emulation modes.
If the unit is set up in Mackie Control emulation mode, and the native support plug-in
is installed in the Logic Express program bundle, Logic Express will detect a US-2400
native control surface and a Mackie Control, plus two Extender (XT) units.
If you want to run the US-2400 in Mackie Control mode, you should remove the US-2400
plug-in from the Logic Express application bundle. Logic Express will then detect a
Mackie Control plus two Extender (XT) units (the appropriate setup for the US-2400 in
Mackie Control emulation mode), when you scan for control surfaces.
The button layout of the Mackie Control differs from that of the Tascam US-2400. When
running the Tascam US-2400 in Mackie Control mode, certain controllers are not
accessible (the Joystick, for example). Given these restrictions, use of the Tascam US-2400
in Mackie Control mode is not recommended. If you choose to do so, refer to the
documentation supplied with the Tascam US-2400 for details.
Tascam US-2400: Assignment Overview
The following sections outline the assignment of Tascam US-2400 interface elements to
Logic functions.
• Tascam US-2400: Channel Strips
• Tascam US-2400: Encoder Details
• Tascam US-2400: Master Channel
• Tascam US-2400: Encoder Assignment Section
• Tascam US-2400: Master Section
Tascam US-2400: Channel Strips
The following table outlines the channel strip controls and their assignments:
Note: A modifier button, such as SHIFT, below a control description indicates that the
control has an alternate function or use while the modifier is held down.
230 Chapter 19 Tascam US-2400