9

AssignmentModifierControl
Saves the active project. The button LED is lit if
the project has been edited since the last Save
operation.
F1
Opens the Save As dialog.SHIFT
Performs an Undo of the last editing operation.
The button LED is lit when a Redo is possible.
F2
Performs a Redo.SHIFT
Copies the current selection (of regions or events)
to the Clipboard.
F3
Cuts the current selection and places it on the
Clipboard.
SHIFT
Pastes the Clipboard contents.F4
Clears the current selection.SHIFT
Master Section (FW-1884, FE-8, FW-1082)
The following table outlines the master controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a button description, it indicates
that the control has an alternate use while the modifier is held down.
AssignmentModifierControl
Identical to (but independent of) the computer
keyboard arrow keys, except when encoders are
in EQ, Plug-in, or Instrument Edit mode.
Cursor buttons
Horizontally or vertically zoom in and out (of the
window with key focus).
SHIFT
Enables Shuttle mode for the wheel.SHTL
Shuttle mode off: moves playhead by one bar.
Shuttle mode on: shuttles playhead.
Wheel
Shows currently selected fader bank. If you only
have an FW-1884, a bank refers to eight channels.
If you have FE-8 extensions added, a bank
encompasses the total number of (physical)
channel strips: 16, 24, and so on. If no LED is lit,
bank 5 or higher is selected.
Bank LEDs
Shifts fader bank down by one bank.< BANK
Shifts fader bank down by one channel.SHIFT
Switches to Mixer (multichannel) view (driver
version 1.20 or later required).
SET
Shifts fader bank up by one bank.BANK >
Shifts fader bank up by one channel.SHIFT
226 Chapter 18 Tascam FW-1884