9

AssignmentModifierMode
Selects EQ band 4.LOW-MID
Selects EQ band 2.SHIFT
Switches the bypass state of EQ band 4 (driver
version 1.20 or later required).
REC
Selects EQ band 3.LOW
Selects EQ band 1.SHIFT
Switches the bypass state of EQ band 3 (driver
version 1.20 or later required).
REC
Encoders and Controls Section (FW-1082 Only)
The three buttons at the bottom of this control surface section determine the mode of
other controls:
• EQ/Pan mode: The controls apply to a certain EQ band of the selected channel.
• AUX 1–4 mode: The controls apply to Sends 1–4.
• AUX 5–8 mode: The controls apply to Sends 5–8.
Note: If a modifier button, such as SHIFT, is shown below a button description, it indicates
that the control has an alternate use while the modifier is held down.
AssignmentModifierMode
While REC is held down, the SEL buttons activate
or deactivate Record Enable for the channel strip.
REC
• EQ/PAN mode: edits the Gain of the currently
selected EQ band.
• AUX 1–4 mode: controls Send 1 level.
• AUX 5–8 mode: controls Send 5 level.
EQ GAIN–AUX 1/5
Selects the channel strip input.SET
• EQ/PAN mode: edits the Frequency of the
currently selected EQ band.
• AUX 1–4 mode: controls Send 2 level.
• AUX 5–8 mode: controls Send 6 level.
EQ FREQ–AUX 2/6
Selects the channel strip output.SET
• EQ/PAN mode: edits the Q Factor of the
currently selected EQ band.
• AUX 1–4 mode: controls Send 3 level.
• AUX 5–8 mode: controls Send 7 level.
EQ Q–AUX 3/7
Selects the channel strip input format.SET
223Chapter 18 Tascam FW-1884