9

AssignmentModifierControl
Disables the Solo state for all channel strips (driver
version 1.20 or later required).
SHIFT
Enables/disables the Mute state of the channel
strip.
MUTE
Disables the Mute state for all channel strips (driver
version 1.20 or later required).
SHIFT
Controls the parameter chosen with the
ENCODERS section.
Encoder
When encoders are controlling a Send level, this
combination allows you to set the send
destination.
SET
Controls the channel strip volume.Fader
EQ Section (FW-1884 Only)
The EQ controls apply to a certain EQ band of the selected channel. A Channel EQ is
automatically inserted in the channel, if not already present.
Note: If a modifier button, such as SHIFT, is shown below a button description, it indicates
that the control has an alternate use while the modifier is held down.
AssignmentModifierMode
While REC is held down, the SEL buttons activate
or deactivate Record Enable for the corresponding
channel strip.
REC
Edits the Gain of the currently selected EQ band.GAIN
Selects the channel strip input.SET
Edits the Frequency parameter of the currently
selected EQ band.
FREQ
Selects the channel strip output.SET
Edits the Q Factor of the currently selected EQ
band.
Q
Selects the channel strip input format.SET
Selects EQ band 6.HIGH
Selects EQ band 8.SHIFT
Switches the bypass state of EQ band 6 (driver
version 1.20 or later required).
REC
Selects EQ band 5.HI-MID
Selects EQ band 7.SHIFT
Switches the bypass state of EQ band 5 (driver
version 1.20 or later required).
REC
222 Chapter 18 Tascam FW-1884