9

AssignmentModifierControl
Switches Solo off for all channel strips.CLR SOLO/F4
Switches Mute off for all channel strips.SHIFT
Creates a new marker at the current playhead
position.
MARKERS/F5
Deletes the marker at the playhead position.SHIFT
Enables/disables Cycle mode.LOOP/F6
Cuts the current selection (of regions or events)
and places it on the Clipboard.
CUT
Deletes the current selection.DEL
Copies the current selection to the Clipboard.COPY
Pastes the Clipboard contents to the current
playhead position.
PASTE
Modifier for other buttons.ALT/CMD
Performs an Undo of the last editing operation.
The button LED is lit when a Redo is possible.
UNDO
Performs a Redo (reverses an Undo operation).SHIFT
Modifier for other buttons.SHIFT
Modifier for other buttons.CTRL
Channel Strips (FW-1884, FE-8, FW-1082)
The following table outlines the channel strip controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a button description, it indicates
that the control has an alternate use while the modifier is held down.
AssignmentModifierControl
These LEDs are lit when the corresponding
channel strip is recording. The LEDs flash when
the channel strip is in Record Enable mode
(armed).
REC LEDs
Selects the channel strip.SEL
Enables/disables Send bypass, when encoders are
controlling a Send level.
SHIFT
Sets the track automation mode to Read.READ
Sets the track automation mode to Write.WRITE
Sets the track automation mode to Touch.TCH
Sets the track automation mode to Latch.LATCH
Enables/disables the Solo state of the channel
strip.
SOLO
221Chapter 18 Tascam FW-1884