9

• SHORTCUTS Section (FW-1884 Only)
• Channel Strips (FW-1884, FE-8, FW-1082)
• EQ Section (FW-1884 Only)
• Encoders and Controls Section (FW-1082 Only)
• MASTER Fader (FW-1884, FE-8, FW-1082)
• Automation/Clock Rate Section (FW-1884 Only)
• Mode Controls Section (FW-1082 Only)
• Master Section (FW-1884, FE-8, FW-1082)
ENCODERS Section (FW-1884, FE-8)
The following table outlines the encoder controls and their assignments:
AssignmentControl
Switches Flip mode between Off and Swap. In Swap mode, the
parameter controlled by the fader and encoder of each channel
strip is swapped.
FLIP
Assigns Pan to encoders.PAN
Assigns Send 1 level to encoders.AUX 1
Assigns Send 2 level to encoders.AUX 2
Assigns Send 3 level to encoders.AUX 3
Assigns Send 4 level to encoders.AUX 4
Assigns Send 5 level to encoders.AUX 5
Assigns Send 6 level to encoders.AUX 6
Assigns Send 7 level to encoders.AUX 7
Assigns Send 8 level to encoders.AUX 8
SHORTCUTS Section (FW-1884 Only)
The following table outlines the shortcut controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a button description, it indicates
that the control has an alternate use while the modifier is held down.
AssignmentModifierControl
Saves the active project. The button LED is lit when
the project has been edited since the last Save
operation.
SAVE/F1
Reverts to the most recently saved version of the
project.
REVERT/F2
Disables the Record Enable buttons of all channel
strips.
ALL SAFE/F3
220 Chapter 18 Tascam FW-1884