9

AssignmentModifierControl
• BYPASS button OFF (see Insert Select mode in
Mackie HUI: ASSIGN Section): selects channel
strip for plug-in selection.
• BYPASS button ON (see Insert Bypass mode in
Mackie HUI: ASSIGN Section): enables/disables
bypass of currently selected Insert slot.
INSERT
• PAN button ON: sets Pan parameter to center
position if DEFAULT button is on.
• Send 1 to 8 selected: edits Send Pre/Post,
activates/deactivates Send Mute, or sets Send
Level to default value.
• In Send Destination Assignment mode, Channel
Strip Input or Channel Strip Output Assignment
mode: the V-SEL buttons confirm your selection.
V-SEL
Adjusts parameter selected in the ASSIGN section.V-Pot
Cycles through automation modes. If you hold
down an automation mode button, pressing AUTO
sets this mode.
AUTO
Enables or disables the Solo button.SOLO
Disables the Solo buttons of all channel strips.OPTION/ALL
Enables or disables the Mute button.MUTE
Disables the Mute buttons of all channel strips.OPTION/ALL
Displays the channel strip name or send, input, or
output assignment.
Scribble strip
Selects the channel strip.SELECT
Sets volume to unity level.SHIFT/ADD
Sets volume to unity level.DEFAULT
Adjusts volume, or duplicates the V-Pot
assignment in Flip mode.
Fader
Mackie HUI: DSP EDIT/ASSIGN Section
The following table outlines the DSP controls and their assignments:
Note: A modifier button, such as SHIFT, below a button description indicates that the
button has an alternate use while the modifier is held down.
AssignmentModifierControl
—ASSIGN
Switches DSP display between “track
name/parameter name” and “parameter
name/parameter value” modes.
COMPARE
180 Chapter 13 Mackie HUI