9

Note: A modifier button, such as SHIFT, below a button description indicates that the
button has an alternate use while the modifier is held down.
AssignmentModifierControl
Assigns Send 1 level to V-Pots, and Send 1 to 4
levels to DSP V-Pots. While SEND A is held down,
the scribble strips show the current Send 1
destination (a bus number).
SEND A
As above, for Send 6SHIFT/ADD
As above, for Send 2SEND B
As above, for Send 7SHIFT/ADD
As above, for Send 3SEND C
As above, for Send 8SHIFT/ADD
As above, for Send 4SEND D
As above, for Send 5SEND E
Assigns Pan to V-Pots, and the selected channel
strip’s pan parameters to DSP V-Pots. You must
confirm any changes made with the DSP V-Pots
by pressing the corresponding V-Select button.
PAN
Assigns channel strip input to V-Pots. While held
down, the scribble strips show the current channel
strip input assignment. The four DSP V-Pots control
the following parameters of the selected channel
strip: format, input, output, and automation mode.
You must confirm any changes made with the
V-Pots or DSP V-Pots by pressing the
corresponding V-Select button.
INPUT
Assigns channel strip output to V-Pots. While held
down, the scribble strips show the current channel
strip output assignment. The four DSP V-Pots
control the following parameters of the selected
channel strip: format, input, output, and
automation mode. You must confirm any changes
made with the V-Pots or DSP V-Pots by pressing
the corresponding V-Select button.
OUTPUT
Disables Record Enable button of all channel strips.REC/RDY ALL
Switches the INSERT buttons between Insert Select
and Insert Bypass modes. See Insert entry in the
Mackie HUI: Channel Strips table.
BYPASS
Switches the V-Select buttons between Send
Position and Send Mute modes.
MUTE
Enables or disables Flip mode.SHIFT
Displays the V-Pot assignment as follows: Pan,
Snd1 to Snd8, S1As to S8As, In, Out.
SELECT-ASSIGN
177Chapter 13 Mackie HUI