9

The controls in the main section have the following meaning:
AssignmentControl
Controls the playhead in one of three modes. (See Pads 1–3 in
Transport Mode.)
Main encoder
Held down in Send mode:
• Main encoder chooses the current send.
• Pads have special meaning—see Send Mode.
• LCDs display send destinations.
• Encoders choose send destinations.
Held down in Effect Edit mode:
• Main encoder chooses the current Insert slot.
• Pads have special meaning—see Effect Edit Mode.
• LCDs display effect names for all eight channels.
SETTING
Enables/disables Duplicate Flip mode. When enabled, both the
faders and encoders control the parameter displayed in the LCDs.
MESSAGE
While held down, Pads switch between Pad functions and channel
views. See Korg microKONTROL and KONTROL49: Pads.
SCENE
—EXIT
Shifts fader bank to the previous eight channels. (LED is on if
previous channels exist.) Shifts fader bank to the previous eight
parameters in Effect Edit or Instrument Edit view.
HEX LOCK
Shifts fader bank to the next eight channels. (LED is on if subsequent
channels exist.) Shifts fader bank to the next eight parameters in
Effect Edit or Instrument Edit view.
ENTER
Octave Shift Down<
Octave Shift Up>
Korg microKONTROL and KONTROL49: Channel Strips
There are several modes for the encoders, enabled with SCENE and Pad 9–16.
AssignmentControl
Shows the parameter controlled by the encoder. The current
name/value is displayed for a few seconds when you move an
encoder or fader. When the encoders are in a Mixer view (Pan, Send,
Send Setup), the background color indicates the channel automation
mode:
• Green: Off or Read
• Yellow: Touch or Latch
• Red: Write
LCD
Controls the parameter shown directly above the encoder in the
LCD.
Encoder
169Chapter 11 Korg microKONTROL and KONTROL49