9

AssignmentModifierControl
While held down, MUTE buttons set automation
mode to Latch.
F4
Sets right locator by current playhead position.SHIFT
While held down, MUTE buttons set automation
mode to Write.
F5
Sets punch in locator by current playhead position.SHIFT
F6
Sets punch out locator by current playhead
position.
SHIFT
Sets pots to Pan/Send mode (display shows “PA”).F7
Enables/disables metronome click.SHIFT
Sets pots to Instrument Edit mode (display shows
“In”).
F8
Sets pots to Effect Edit mode (display shows
“P1”–“P9”).
F9
JLCooper CS-32 MiniDesk: Cursor Section
The following table outlines the cursor controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a description, it indicates that
the control has an alternate use while the modifier is held down.
AssignmentModifierControl
Zooms out vertically.Up
In Effect Edit mode: moves up one Insert slot
(unless top slot is selected).
SHIFT
Zooms in vertically.Down
In Effect Edit mode: moves down one Insert slot
(unless bottom slot).
SHIFT
Zooms out horizontally.Left
In Instrument and Effect Edit modes: decrements
current parameter bank (moves down one bank,
or page, of parameters).
SHIFT
Zooms in horizontally.Right
In Instrument and Effect Edit modes: increments
current parameter bank (moves up one bank, or
page, of parameters).
SHIFT
JLCooper CS-32 MiniDesk: Transport Section
The following table outlines the transport controls and their assignments:
156 Chapter 8 JLCooper CS-32 MiniDesk