9

AssignmentModifierControl
Switches automation mode between Read and
Off (display shows “Td”).
F2
Switches automation mode between Touch and
Off (display shows “Tc”).
F3
Switches automation mode between Latch and
Off (display shows “Lt”).
F4
Switches automation mode between Write and
Off (display shows “Wr”).
F5
Activates/deactivates Record Enable button.ARM
Control volume. As the faders don’t offer feedback,
Pickup mode is used, as per the pots. See the
pickup information in JLCooper CS-32 MiniDesk:
Pots.
Faders
JLCooper CS-32 MiniDesk: Bank Button
The following table outlines the bank controls and their assignments:
AssignmentControl
LED off: Black labels of channel strip buttons apply (TRK/LOC/ARM).
LED on: White labels of channel strip buttons apply
(PAN/SOLO/MUTE).
Small red button with green LED
JLCooper CS-32 MiniDesk: F Key Section
The following table outlines the F key controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a description, it indicates that
the control has an alternate use while the modifier is held down.
AssignmentModifierControl
Modifier for function of other controls. See SHIFT
entries in left column.
SHIFT
While held down, MUTE buttons 1–6
enable/disable automation of certain parameters
(see MUTE).
F1
Enables/disables Cycle mode.SHIFT
While held down, MUTE buttons set automation
mode to Read.
F2
Enables/disables Autopunch mode.SHIFT
While held down, MUTE buttons set automation
mode to Touch.
F3
Sets left locator by current playhead position.SHIFT
155Chapter 8 JLCooper CS-32 MiniDesk