9

Note: With SHIFT held down (display shows “b1”–“b9”), you can move between banks
(pages) of parameters. (See JLCooper CS-32 MiniDesk: Cursor Section.)
Effect Edit Mode
Press F9 to enter Effect Edit mode (display shows “P1”–“P9”). The pots control the
parameters of the effect in the currently selected Insert slot.
Note: With SHIFT held down (display shows “b1”–“b9”), you can switch between Insert
slots, and move between banks (pages) of parameters. (See JLCooper CS-32 MiniDesk:
Cursor Section.)
JLCooper CS-32 MiniDesk: Channel Strips
The following table outlines the channel strip controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a description, it indicates that
the control has an alternate use while the modifier is held down.
AssignmentModifierControl
Selects channel strip (destination for the selected
track).
PAN SELECT/TRACK
SELECT
Enables/disables Solo.SOLO
Moves playhead to markers 1 to 32.LOCATE
LOCATE 17: Creates a new marker.
LOCATE 18: Creates a new marker without
rounding.
LOCATE 19: Deletes the marker at the playhead
position.
LOCATE 25: Opens the Marker List.
LOCATE 26: Opens the Marker Text window.
LOCATE 28: Sets locators by previous marker.
LOCATE 29: Sets locators by current marker.
LOCATE 30: Sets locators by next marker.
LOCATE 31: Moves playhead to previous marker.
LOCATE 32: Moves playhead to next marker.
SHIFT
Enables/disables Mute.MUTE
Automation Enable setup (display shows “AE”).
MUTE 1: Enables/disables volume automation.
MUTE 2: Enables/disables pan automation.
MUTE 3: Enables/disables mute automation.
MUTE 4: Enables/disables automation of solo.
MUTE 5: Enables/disables send (level) automation.
MUTE 6: Enables/disables automation of plug-in
parameters.
F1
154 Chapter 8 JLCooper CS-32 MiniDesk