9

AssignmentModifierControl
While ALL/ALT/FINE is held down, rotary encoders
are in Full mode: rotating counterclockwise sets
minimum, rotating clockwise sets maximum value.
ALL/ALT/FINE
While SHIFT and ALL/ALT/FINE are held down,
rotary encoders are in Fine mode. Parameter
changes are made in single unit (or smaller) values.
SHIFT
Currently unassignedDEFAULT/bypass
In Instrument Edit mode: switches bypass state of
the instrument. In Effect Edit mode: switches
bypass state of the effect being edited.
SHIFT
Performs an Undo step. The LED is lit if there is a
Redo step available.
UNDO/save
Saves the project. The LED is lit if the project
contains unsaved changes.
SHIFT
Switches to Shift mode, where the functions
indicated by the (inverted) labels below the
buttons apply.
SHIFT
CM Labs Motormix: Faders
The faders normally control volume. When in Flip mode, however, they duplicate the
rotary encoder assignments.
CM Labs Motormix: Right Function Buttons
The following table outlines the right function button controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a button description, it indicates
that the control has an alternate use while the modifier is held down.
AssignmentModifierControl
Play key commandPLAY/transport
Switches Select buttons to Transport Section
mode.
SHIFT
Stop key commandSTOP/locate
Switches Select buttons to Locate mode.SHIFT
Shuttle Forward key commandFFWD/monitor
Shuttle Rewind key commandREWIND/status
Opens Project Settings Synchronization window.SHIFT
Moves playhead to next marker.NEXT/configure
When rotary encoders are displaying send
destinations, use of LAST/assign reverts to
displaying send levels. Otherwise, moves playhead
to previous marker.
LAST/assign
144 Chapter 6 CM Labs Motormix