9

To change the output destination of a channel strip
1 Press the Mix or Output knob top, or key, to display all possible mix or output values for
the currently selected channel strip.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
The value names are displayed on the Soft Keys, the touchscreen, or the display, depending
on the system you are using.
2 To select the output destination, do one of the following:
• Press the knob top that features the name of the mix or output value.
• Press the On key for the relevant mix or output value.
You can use the Page keys to display ensuing outputs.
The currently active output is indicated by a lit On key (on the MC Professional and MC Mix
devices). On the MC Control, it is indicated by a small green LED in the lower left of the
knob image.
3 Press the Back key to return to the top-level knobset.
Euphonix: Other Features Specific to Logic Express
This section describes other features specific to Logic Express.
• Layouts: Tracks assigned to channel strips can be saved as a Layout. This Layout can
then be recalled at a later time. Any Layouts saved on Euphonix devices are automatically
saved with the Logic Express project.
• Monitors and Control Room: Logic Express does not support EuCon monitoring control.
Use the Studio Monitor Pro application.
• Track control bar: The track control bar of the Logic Express Arrange area offers a special
feature on the Euphonix devices: it shows attentioned tracks in blue.
Note: The color of the track control bar cannot be changed in the Control Surfaces Setup
window.
135Chapter 5 Euphonix MC Pro, System 5-MC, MC Control, MC Mix, and MC Transport