8

Chapter 3 Mackie Control 95
Cycle View
Pressing the SHIFT and CYCLE buttons activates Cycle View mode:
 The mode display shows “Cy”.
 V-Pot 1—shows and edits the current cycle status (off or on); you can also use the
CYCLE button.
 V-Pot 2—BySel—sets the current cycle area by the selection made in the Arrange
window (selected audio or MIDI region).
 V-Pot 3—Move—moves the current cycle by a bar with each click, when turning the
V-Pot.
 The display shows the left and right locators above V-Pots 5 and 7.
 Pressing V-Pot 5 picks up the current playhead position for the left locator.
 Turning V-Pot 5 changes the left locator in bars.
 Turning V-Pot 6 changes the left locator in beats (denominator steps).
 Pressing V-Pot 7 picks up the current playhead position for the right locator.
 Turning V-Pot 7 changes the right locator in bars.
 Turning V-Pot 8 changes the right locator in beats (denominator steps).
To return to a regular Assignment mode, press one of the Assignment buttons.
Drop
Activates/deactivates Autopunch mode.
To navigate between punch-in areas:
1 Press the MARKER button.
2 Press the DROP button, and when active, press the FAST FWD or REWIND buttons.
To set the punch in or punch out locator to the current playhead position:
m Hold down DROP and press FAST FWD or REWIND. This also enables Autopunch mode.
The fastest way to define a new punch in area is to:
1 Navigate to the desired punch in locator position with the Jog/Scrub Wheel.
2 Press DROP and REWIND.
3 Navigate to the desired punch out locator position with the Jog/Scrub Wheel.
4 Press DROP and FAST FWD.