8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 3 Mackie Control 75
Send Button
Pressing the SEND button activates Send Mixer view. Pressing the button repeatedly
switches between Send Channel view and Send Mixer view.
Send Mixer View
Send Mixer view allows you to edit one send parameter for all channel strips:
Destination, Level, Position, or Mute. The Send slot number, and the parameter being
edited, are displayed briefly on the LCD when switching to this mode.
 The mode display shows S1 to S8, indicating the selected Send slot.
 The upper LCD row shows channel strip names.
 Turning the V-Pots changes the current Send parameter.
 Pressing a V-Pot confirms the pre-selected send destination, and sets the other send
parameters to their defaults.
 Cursor Up/Down switches to the next or previous Send slot.
 Cursor Left/Right switches to the next or previous send parameter. The selected
parameter appears briefly in the upper LCD row.
 Pressing a MUTE button while holding down the SHIFT button switches the current
send’s mute status.
 When Flip mode is enabled, the MUTE buttons display, and edit, the current send’s
mute status.
Note: Ensure that the ZOOM button isn’t active when using the cursor buttons.
Send Channel View
Send Channel view allows you to edit all send parameters for the selected channel
strip. The mode display shows “SE.” (for send channel strip). The upper row of the LCD
shows the name of the channel strip, the text “Sends”, the page number, and total
number of pages—“Page 1/4”, for example.
The Left/Right cursor buttons shift between pages. The number of sends that can be
displayed simultaneously is dependent on the number of Mackie Control XTs you have.
Note: Ensure that the ZOOM button isn’t active when using the cursor buttons.
Control Action
V-Pot 1 Edits the destination of odd-numbered sends.
V-Pot 2 Edits the (send amount) level of odd-numbered sends.
V-Pot 3 Edits the position (pre/post) of odd-numbered sends.
V-Pot 4 Sets the mute status of odd-numbered sends.
V-Pot 5 Edits the destination of even-numbered sends.
V-Pot 6 Edits the (send amount) level of even-numbered sends.
V-Pot 7 Edits the position (pre/post) of even-numbered sends.
V-Pot 8 Sets the mute status of even-numbered sends.