8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
74 Chapter 3 Mackie Control
The Left and Right cursors switch to the next or previous EQ band. The LCD displays
two EQ bands. If you have one or more connected Mackie Control (XT) units, each XT
can display two EQ bands—up to a total of eight.
Note: Ensure that the ZOOM button isn’t active when using the cursor buttons.
Alternate EQ Edit Mode Options
Holding down the EQ button accesses a further sub-menu in the LCD. The mode
display shows E_ or E_., dependent on whether you are in EQ Mixer or EQ Channel
view mode.
Note: The faders form a frequency response curve in this mode, if the EQ bands have
ascending frequency values.
∏ Tip: You can edit another channel strip’s EQ without leaving this view by simply
selecting the channel strip in Logic Express, or by pressing the appropriate Select
button on the Mackie Control.
Control Action
V-Pot 1 or F1 Switches to EQ Mixer view and selects frequency.
V-Pot 2 or F2 Switches to EQ Mixer view and selects gain.
V-Pot 3 or F3 Switches to EQ Mixer view and selects Q.
V-Pot 4 or F4 Switches to EQ Mixer view and selects bypass.
V-Pot 6 or F6 Switches to EQ Channel view.
V-Pot 7 or F7 Switches to Frequency/Gain Mixer view. In this mode, you can edit
the frequency and gain parameters of a specific EQ band (1 to 8)
for all channel strips.
 The mode display shows F1 to F8, indicating the selected EQ
band.
 The upper LCD row shows channel strip names.
 The lower LCD row shows the frequency of the selected EQ band.
 Turning a V-Pot changes EQ frequency.
 Pressing a V-Pot sets the EQ frequency to its default value.
 Use the Mute buttons to bypass the EQ.
 Use the faders to adjust the EQ gain.
V-Pot 8 or F8 Switches to Frequency/Gain Channel view. In this mode, you can
edit the frequency and gain parameters for all EQ bands of the
selected channel strip. Each pair of channel strips corresponds to
one EQ band.
 The mode display shows FG.
 V-Pots 1 to 8 control the frequency of EQ bands 1 to 8.
 Mute buttons 1 to 8 control the bypass of EQ bands 1 to 8.
 Faders 1 to 8 control the gain of EQ bands 1 to 8.