8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
46 Chapter 2 Customizing Controller Assignments
Defining Zones and Modes
You can only define Zones and Modes in Expert view.
To define a zone:
1 Click the Add button at the lower-left corner of the Zone list.
A new, blank zone appears in the Zone list. It is highlighted, allowing you to
immediately rename it.
2 Type in a name for the zone.
If you would like to add controllers to a zone, see “Assigning Controllers in Expert View”
on page 44.
To define a mode:
1 Click the Add button at the lower-left corner of the Mode list.
A new, blank mode appears in the Mode list. It is highlighted, allowing you to
immediately rename it.
2 Type in a name for the mode.
If you would like to add controllers to a mode, see “Assigning Controllers in Expert
View” on page 44.