8

32 Chapter 1 Basic Control Surface Setup
 Only when all parameters fit in one page: When turned on, the defined number of
encoders are only used when enough encoders are available to show all parameters
(without having to change pages). As an example, if you have a Mackie Control and
two Mackie Control XTs (giving you a total of 24 encoders), a plug-in with 13
parameters will be shown with one encoder per parameter. Eleven encoders will
remain unused. A plug-in with 11 parameters will be shown with two encoders per
parameter. Two encoders will remain unused (as will the inactive encoders of the
sub-divisions mentioned above).
When turned off, multiple encoders are used for each parameter, which may require
scrolling. This would not be the case if only one encoder was used for each
parameter.
 Show value units for: The two checkboxes in this section allow you to adjust whether
or not parameter values are appended by the measurement unit, where applicable—
“Hz” or “%,” for example. You can set this option separately for instrument/plug-in
parameters, and for volume and other channel strip parameters. When turned on,
parameter values are appended with the appropriate unit, where applicable. Turn off
if viewing units makes the display too cluttered.
 Controller Assignments button: Click to open the Controller Assignments window.
 Setup button: Click to open the Control Surfaces Setup window.