8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
20
225
20 Yamaha DM1000
Setting Up Your Yamaha DM1000
Please follow these steps before using your control surface with Logic Express.
 Make sure that your DM1000 units are connected to the computer via USB.
 Make sure that the MIDI driver shipped with the unit is installed.
On the DM1000 Front Panel:
1 Press the DISPLAY ACCESS [SETUP] button repeatedly, until the Setup/MIDI/Host page is
visible.
2 Move the cursor to the first DAW parameter box in the Special Functions section, and
rotate the parameter wheel to select USB and 1–3.
3 Press the DISPLAY ACCESS [REMOTE] button, and then press the [F1] button. The Setup/
Remote 1 page is displayed.
4 Rotate the parameter wheel to choose General DAW as the TARGET parameter.
5 Press the LAYER [REMOTE 1] button.
In Logic Express:
When you open Logic Express, the unit is installed automatically. You should see three
DM1000 (USB 1–3) icons in the Setup window, aligned horizontally.