8

222 Chapter 19 Yamaha 02R96
LCD
The LCD displays different data, depending on the page selected with the F2, F3, and
F4 buttons:
 INSERT ASSIGN/EDIT Display mode: Parameter details, plug-in selection, or plug-in
parameters. Press [F2] to select this mode (for details on the assignments, see table
below).
 Channel view mode: Encoder values and channel strip display. Press [F3] to select
this mode.
 Level meters view mode: Press [F4] to select this mode.
The following assignments are available in all three modes:
USER DEFINED KEYS Section
Display Assignment
TIME CODE Active if counter is displaying SMPTE time code.
BEATS Active if counter is displaying bars/beats/divisions/ticks.
Counter
display
Displays SMPTE time code or bars/beats/divisions/ticks.
SELECT ASSIGN Displays the Encoder assignment as follows:
Pan, Snd1 to Snd8, S1As to S8As, In, Out.
Control Assignment
display While held, the channel strip displays show the automation mode of the selected
channels.
1 Switches between the Arrange and Mixer windows.
2 Enables/disables the Group Clutch.
3 Sets selected track/channel to Write automation mode.
4 Sets selected track/channel to Touch automation mode.
5 Sets selected track/channel to Latch automation mode.
6 Sets selected track/channel to Read automation mode.
8 Sets selected track/channel to Off automation mode.
9 Shifts channel strips by one bank (a bank is a group of channels or parameters) to
the left.
10 Shifts channel strips by one bank to the right.
11 Enables/disables volume automation playback and recording.
12 Enables/disables mute automation playback and recording.
13 Enables/disables pan automation playback and recording.
14 Enables/disables send level automation playback and recording.
16 Enables/disables plug-in parameter automation playback and recording.