8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
220 Chapter 19 Yamaha 02R96
Assignment Overview
A modifier button (such as SHIFT) below a button description indicates that the button
has an alternate function, while holding down this modifier.
DISPLAY ACCESS Section
AUX SELECT Section
ENCODER MODE Section
FADER MODE Section
Control Assignment
METER Clears Overload LEDs.
Control Assignment
AUX 1 Assigns Send 1 level to encoders, and Send 1 to 4 levels to rotary knobs shown in
display. While held, the channel strip displays show the current Send 1 destination
assignment.
AUX 2 Assigns Send 2 level to encoders, and Send 1 to 4 levels to rotary knobs shown in
display. While held, the channel strip displays show the current Send 2 destination
assignment.
AUX 3 Assigns Send 3 level to encoders, and Send 1 to 4 levels to rotary knobs shown in
display. While held, the channel strip displays show the current Send 3 destination
assignment.
AUX 4 Assigns Send 4 level to encoders, and Send 1 to 4 levels to rotary knobs shown in
display. While held, the channel strip displays show the current Send 4 destination
assignment.
AUX 5 Assigns Send 5 level to encoders, and Send 5 to 8 levels to rotary knobs shown in
display. While held, the channel strip displays show the current Send 5 destination
assignment.
Control Assignment
PAN Assigns pan to encoders; assigns selected channel’s pan parameters to display
encoders.
AUX Assigns Send 1 level to encoders, and Send 1 to 4 levels to DSP encoders. While held,
the channel strip displays show the current Send 1 destination assignment.
Control Assignment
FADER Enables or disables Flip mode.
AUX/MTRX Enables or disables Flip mode.