8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
208 Chapter 17 Tascam US-428 and US-224
Channel Strips
EQ Section
Control Assignment
MUTE 1 to 8 SOLO LED off: Switches Mute on/off; LED displays Mute status.
SOLO LED on: Switches Solo on/off; LED displays Solo status.
REC 1 to 8 LEDs Displays Record Enable status.
NULL On if fader is higher than actual channel volume (in Logic Express).
SELECT 1 to 8 LEDs Displays select status (of channel).
NULL On if fader is lower than actual channel volume (in Logic Express).
SELECT 1 to 8 buttons Selects channel.
REC Activates/deactivates Record Enable status.
Fader 1 to 8 Controls channel volume.
NULL Allows you to update the fader position to match the actual volume (in
Logic Express).
Master fader Controls Master volume fader (or Output 1 and 2, if no Master fader channel
exists in project).
Control Assignment
Gain Controls the Gain of the currently selected EQ band (of chosen channel).
Freq Controls the Frequency of the currently selected EQ band (of chosen channel).
Q Controls Q factor of the currently selected EQ band (of chosen channel).
HIGH Selects EQ band 3 (allowing use of Gain, Freq, and Q controls for this band).
ASGN Switches EQ band 3 bypass state.
HI-MID Selects EQ band 4 (allowing use of Gain, Freq, and Q controls for this band).
ASGN Switches EQ band 4 bypass state.
LO-MID Selects EQ band 5 (allowing use of Gain, Freq, and Q controls for this band).
ASGN Switches EQ band 5 bypass state.
LOW Selects EQ band 6 (allowing use of Gain, Freq, and Q controls for this band).
ASGN Switches EQ band 6 bypass state.