8

Chapter 16 Tascam US-2400 205
Instrument Edit View
In Instrument Edit view, the following AUX buttons have special assignments:
The AUX button LEDs show the currently selected parameter bank. AUX 2 LED is on if
parameters 25–48 are shown on the encoders.
Plug-in Edit View
In Plug-in Edit view, the following AUX buttons have special assignments:
The AUX button LEDs show the currently selected Insert slot. As an example: AUX 2
LED is on if Insert slot 2 is being edited.
Master Section
Control Assignment
AUX 1 Scrolls parameter fader bank left—by 24 parameters.
AUX 2 Scrolls parameter fader bank right—by 24 parameters.
AUX 4 Enables/Disables Bypass button of the instrument being edited.
Control Assignment
AUX 1 Scrolls parameter fader bank left—by 24 parameters.
AUX 2 Scrolls parameter fader bank right—by 24 parameters.
AUX 3 Increments Insert slot (chooses higher numbered slot).
AUX 4 Enables/Disables Bypass button of the plug-in being edited.
AUX 6 Decrements Insert slot (chooses lower numbered slot).
Control Assignment
MTR Switches encoder LED ring display between two modes:
 The value of the parameter (LED off).
 Level/peak hold meters (LED on).
In Level Meter mode, the LED below the encoder displays signal overloads
(clipping).
F-KEY Modifier key, used to switch the function of other controls (see “F-KEY” entries
in left column).
NULL Sets Panning of selected channel to center position—LED is on if Pan is
centered.
F-KEY Resets overload display for level meters.
Jog Wheel SCRUB off: Moves playhead by bars.
SCRUB on: Scrubbing (of audio and MIDI).
SCRUB flashing: Shuttle mode.
Joystick Edits Panning of selected channel.
SCRUB Switches Jog Wheel between “Move Playhead by Bars” (LED off ) and Scrubbing
(LED on) modes.
SHIFT Sets Jog Wheel to Shuttle mode (LED flashes).