8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 16 Tascam US-2400 203
Master Channel
Control Assignment
SEL Selects Master Output channel strip (if it exists—if not, Output channel 1-2 is
selected).
CLR SOLO Disables Solo for all tracks/channels.
SHIFT Disables Mute for all tracks/channels.
F-KEY Disables the Record Enable buttons of all tracks/channels.
FLIP Switches Flip mode between Off (LED off) and Duplicate (LED on).
In this mode, the fader of each channel strip mirrors the encoder function.
SHIFT Sets Flip mode to Swap (LED flashing).
In this mode, the parameters controlled by the fader and encoder are
swapped.
F-KEY Sets Flip mode to Zero—fader motors are disabled (LED flashing).