8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
200 Chapter 16 Tascam US-2400
Assignment Overview
A modifier button (such as SHIFT) below a button description indicates that the button
has an alternate function/use, while holding down this modifier.
Channel Strips
Control Assignment
Encoders CHAN button on: see “Encoder Details” on page 201.
CHAN button flashing: Encoders control Instrument parameters, also see
“Instrument Edit View” on page 205.
PAN button flashing: Encoders control plug-in parameters, also see “Plug-in
Edit View” on page 205.
Other modes: Encoders control the parameters of the active mode.
F-KEY Â If you are in Instrument Edit view (CHAN button flashing), pressing the F-Key
enters the Instrument Assignment view: The encoders are used to choose an
instrument plug-in from the list (of available software instrument plug-ins).
 If you are in Plug-in Edit view (PAN button flashing), pressing the F-Key enters
the Plug-in Assignment view: The encoders are used to choose an effect
plug-in from the list (of available effect plug-ins).
 If you are in Send view (AUX button LED flashes) and press the F-Key, the
encoders are used to assign the send destination.
SEL buttons Select tracks/channels.
SHIFT In Pan view: sets volume to Unity (0 dB).
In Send views: switches the Send mode (pre/post).
F-KEY Activates/Deactivates Record Enable button of each channel.
SOLO buttons Enables/Disables Solo.
MUTE buttons Enables/Disables Mute.
In Send views with Flip mode enabled: mutes/unmutes the selected Send.
SHIFT In Send views: mutes/unmutes the selected Send.
Faders Control the volume of each channel (unless duplicate or swap Flip mode is
active).