8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
196 Chapter 15 Tascam FW-1884
Automation/Clock Rate Section (FW-1884 Only)
Mode Controls Section (FW-1082 Only)
Control Assignment
READ While held down, SEL buttons are lit if a channel is in Read automation mode.
Pressing the SEL button sets Read mode. Turning the encoder also edits the
automation mode.
WRITE While held down, SEL buttons are lit if a channel is in Write automation mode.
Pressing the SEL button sets Write mode. Turning the encoder also edits the
automation mode.
TCH While held down, SEL buttons are lit if a channel is in Touch automation mode.
Pressing the SEL button sets Touch mode. Turning the encoder also edits the
automation mode.
LATCH While held down, SEL buttons are lit if a channel is in Latch automation mode.
Pressing the SEL button sets Latch mode. Turning the encoder also edits the
automation mode.
F7 Switches encoders to editing of pan
F8 Switches encoders to Channel view: EQ Edit mode for the selected channel.
See upper line of SoftLCD application for parameter assignment details. Cursor
left/right shifts the parameter bank (a bank is a group of channels or
parameters).
F9 Switches encoders to Channel view: Plug-in Edit mode for the selected
channel. Cursor left/right shifts parameter bank (each bank can be viewed as a
page of plug-in parameters). Cursor up/down chooses the channel Insert slot
for editing.
F10 Switches encoders to Channel view: Instrument Edit mode for the selected
channel. Cursor left/right shifts parameter bank.
Control Assignment
F1 Saves the active project. The button LED is lit if the project has been edited
since the last save operation.
SHIFT Opens the Save As dialog.
F2 Performs an Undo (of the last editing operation). The button LED is lit when a
Redo is possible.
SHIFT Performs a Redo.
F3 Copies the current selection (of regions or events) to the Clipboard.
SHIFT Cuts the current selection, and places it in the Clipboard.
F4 Pastes the Clipboard contents.
SHIFT Clears the current selection.