8
Table Of Contents
- Logic Express 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Express
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 15 Tascam FW-1884 191
SHORTCUTS Section (FW-1884 Only)
Control Assignment
SAVE/F1 Saves the active project. The button LED is lit when the project has been
edited since the last save operation.
REVERT/F2 Reverts to the most recently saved version of the project.
ALL SAFE/F3 Disables the Record Enable buttons of all channels.
CLR SOLO/F4 Switches Solo off for all channels.
SHIFT Switches Mute off for all channels.
MARKERS/F5 Creates a new marker at the current playhead position.
SHIFT Deletes the marker at the playhead position.
LOOP/F6 Enables/Disables Cycle mode.
CUT Cuts the current selection (of regions or events) and places it in the Clipboard.
DEL Deletes the current selection.
COPY Copies the current selection to the Clipboard.
PASTE Pastes the Clipboard contents to the current playhead position.
ALT/CMD Modifier for other buttons.
UNDO Performs an Undo (of the last editing operation). The button LED is lit when a
Redo is possible.
SHIFT Performs a Redo (reverses an Undo operation).
SHIFT Modifier for other buttons.
CTRL Modifier for other buttons.